3D Printer Enclosures from 3DUPfitters

Introducing a huge acrylic enclosure for the Creality CR-10 Max

Introducing a huge acrylic enclosure for the Creality CR-10 Max

by Michael Czeiszperger
Hot out of our R&D field test is the new CR10 Max 3D printer enclosure with a huge 450x450x470mm build space. The enclosure is also huge and ma...
Creality enclosure
Enclosure vs. Paving Stones: Measuring Prusa MK3S 3D Printer Noise

Enclosure vs. Paving Stones: Measuring Prusa MK3S 3D Printer Noise

by Michael Czeiszperger
First, I'll just say off the bat that we welcome and encourage customers to DIY whatever setup they want, and we will gladly give advice on how to ...
3d printer 3D Printer Enclosure enclosure Mk3S noise paver stones paving stones Prusa Prusa MK3S
3D Printing PLA, PETG and ABS while Protecting Your Lungs with an Enclosure

3D Printing PLA, PETG and ABS while Protecting Your Lungs with an Enclosure

by Michael Czeiszperger
A lot of 3D printer enthusiasts start out putting a cardboard box over the printer, but there’s a lot more to it than that!  This article will expl...
3d printer 3d printing enclosure Sticky temperature tutorial
Ender 5 Plus Settings for Simplify3D

Ender 5 Plus Settings for Simplify3D

by Michael Czeiszperger
At 3DUPfitters we are big fans of Simplify3D, but sometimes they don't always publish a profile for your printer.  (Or one that's not so great.) In...
3D Printer Enclosure Ender Ender 5
3D Printing with PLA Inside an Enclosure

3D Printing with PLA Inside an Enclosure

by Michael Czeiszperger

After a couple of posts appeared online about problems printing PLA inside an enclosure we were contacted by a customer asking if the enclosure would harm their stepper motors or cause clogs.  

Michael Czeiszperger, B.S.E.E. The Ohio State University

Clog enclosure Prusa